CNC Setups: YASNAC LX1
Hooking up the Yasnac LX1 control to an RS-232 signal
is done through a DB25 pin connector located below the tape reader on the control door.
G-ZERO needs to be set for even parity, 7 data bits, and 1 stop bit with a recommended
baud rate of 1200.
Pin Description
| YASNAC LX1 | Computer (25-pin) | Computer (9-pin) |
| ..... | 1 Not Connected | 1 Carrier Detect (CD) |
| 2 Send Data (SD) | 2 Send Data (SD) | 2 Receive Data (RD) |
| 3 Receive Data (RD) | 3 Receive Data (RD) | 3 Send Data (SD) |
| 4 Ready To Send (RTS) | 4 Ready To Send (RTS) | 4 Data Terminal Ready (DTR) |
| 5 Clear To Send (CTS) | 5 Clear To Send (CTS) | 5 Signal Ground (SG) |
| 6 Data Ready (DR) | 6 Data Ready (DR) | 6 Data Ready (DR) |
| 7 Signal Ground (SG) | 7 Signal Ground (SG) | 7 Ready To Send (RTS) |
| 8 Carrier Detect (CD) | 8 Carrier Detect (CD) | 8 Clear To Send (CTS) |
| ..... | ..... | 9 Ring Indicator (RI) |
| 20 Data Terminal Ready (DTR) | 20 Data Terminal Ready (DTR) |
Use cable with following connections
OPTIONAL - Hardware Handshake
Parameters
